Shopping

These new double shear bearing suspension cages are the strongest on the market. Cages are built with our Quick Adjust Technology, so to make a 4 bar adjustment you simply loosen the bolt, pop out the puck spacer, move the bar, and tighten. Spacer package has high misalignment built in for maximum travel. Fully modular so crash repair is simple unlike a welded cage.

• Standard cage comes with 4”, 5”, 6” & 7” shock drops
• 4 bar rods have 5 holes on the top and bottom to change indexing
• 9” standard bar spacing
• Cage comes complete with clamp rings and all hardware

• Double Sided Climber Pinion Mount on Arc
• Same arc as our WM205 with the extra arc slot on left side of the pinion
• Mount adjusts easily with our climber nut

• Steel arc climbing frame mount side of the 1-1/2"x1-1/2" tube
• Mount is 2-1/2" off tube centerline
• Can be used on either side of the tube by flipping over
• Slot is 2" long
• Mount comes with back nut & climber gear

• Grand National Hub Dust Cover
• Billet dust caps
• Made thicker so they last longer
• Uses a square o-ring so it stays put during installation

Lots of new trickery on this new dual bearing spring slider. We use a linear ball shaft bearing instead of bronze bushing along with a shaft stabilizing internal piston for the smoothest and most stable slider on the market. The spring cup opposite the adjusting nut is quickly removed with a clip, so you don’t have to unscrew the nut to remove the spring.

• Four position locking mechanism for fine tuning
• Torrington bearing on adjuster nut so you can adjust it easily
• Spring works freely throughout its travel
• 24" standard slider length
• Fine thread

Just like our aluminum one, only made out of steel dom tubing, has two inches of adjustment like the aluminum one - just a little heavier.

• Double Adjustable J-Bar
• Steel Construction
• Bar Length is 20"-22"

• Interior Tin Tube Notcher
• Notch your tin quick and easy with this cool tool
• Available Sizes: 1-1/4", 1-1/2" or 1-3/4" Tube

These are a cross between a bolt and a shock pin. Don't trust the pin? These use a nut, like a bolt would.

• Spacer part is machined on like the pins
• Thread is 1/2" -13 coarse.
• Available in 2-1/8" short or 2-3/4" long steel bolt.
• Sold each.

• Tool aggressively shrinks sheet metal
• Great for forming curves in hoods, fenders, A-pillars and more on the bodies of race cars
• Designed for an aggressive shrink on a double fold 90 degree bend
• Will shrink hemmed edges of .040 aluminum
• Ratio of the vise grip makes easy work of the double folds