Shopping

• Billet aluminum spacer fits between intake manifold and water neck
• Provides connection options for temperature senders or additional water lines
• 1" tall spacer includes four 1/2" NPT ports with plugs and an O-ring seal on one side eliminating the need for a gasket

• Mount a spoiler or use as a lower quarter panel or nose support
• Adjusts from 16" to 28" and can be shortened as needed
• Sold each

• Aluminum plates simplify setting of toe-in and toe-out.
• Plates fit against outside edges of tires. Using two tape measures (sold separately), measure the distance front and rear, between plates.
• The difference in tape readings is the toe setting.
• Deluxe plates have radiused edges, slots for narrow and wide tape measures and are 9" tall x 23" wide to work with vehicles with smaller wheel openings.
• Set of two plates

• No more extensions slipping off.
• 1" hex socket is 6" in length.
• Clears beadlock ring on Weld Wheels.
• 1/2" drive.

• Sprint Top Wing Cap
• Prevent rock and debris from damaging the leading edge of most popular Sprint car wings with a protective cap
• Constructed of high-impact plastic
• 60" Length

• 7-1/2" long stainless steel cable ties
• An excellent choice when securing header wrap to exhaust tubes
• Work great when nylon wraps won't stand up to the heat
• Rust and corrosion resistant cable ties are T-304 stainless
• Sold as 8/Pack

• Aluminum exhaust block off plate set
• 1/16" 1-piece design seal spread port SB Chevy exhaust ports
• Work great during engine storage or repairs
• Plates protect against moisture, dust and dirt
• Sold in Pairs

• Residual check valves hold a small amount of pressure in the brake system to keep the brake system functioning properly while helping to maintain a firm pedal.
• Maintaining system pressure prevents fluid from returning to the master cylinder when the master cylinder is positioned lower than or close to the same height as the calipers or wheel cylinders.
• Proper system pressure also keeps piston and wheel cylinder seals expanded creating a positive seal and brake pads seated against the rotor.
• Valves include two 3/16" inverted flare fittings.

• Plastic Cap Kit
• A must for keeping debris out of lines and hoses
• Ideal for keeping internal components of dry sump pumps, fuel pumps, pressure regulators, etc. clean during storage
• Caps and plugs fit 37° flared fittings and straight threaded ports
• Kit includes 5 of each size -03 to -16 AN