Shopping

• Body radius tool
• Solid oak tool can be used to flare edges of wheel openings when fabricating fenders and quarter panels out of aluminum
• Tool has two different radiuses to create the correct flare for your needs

• Tie downs are great for securing vehicles and pit equipment during transport.
• 2" x 8' long straps have heavy duty plated hardware,
• Ratchet designed to hold excess strap material as it is pulled through and wrapped up during tightening.
• The working load limit is the maximum load a strap should be subjected to during normal use.

• Hammer type spring steel punch
• Spring steel punch places a 1/4" diameter hole 1/2" from the end of Allstar's 1" x .062" thick spring steel material
• Built-in stop positions material for accurate hole placement
• Place on a hard surface and strike with a 3 to 4lb hammer

• Steering Shaft Rod End Kit
• Mounts to steering column bracket to hold steering shaft in place.
• Kit includes one rod end and two steel 3/4" RH jam nuts.
• Rod end is .757" I.D. (.007" oversized) to slide over a 3/4" O.D. shaft.

• Axle straps or winch straps work great for wrapping around the chassis or axle tubes when securing a vehicle to the trailer or when winching a vehicle.
• Adjustable protective sleeve can be positioned as needed to help prevent strap damage from sharp edges.
• The working load limit is the maximum load a strap should be subjected to during normal use.
• Axle Strap With Twist Hooks, Adjustable 24"-40"

• GM Metric Spindle Checker Tool Kit with 2" Taper.
• Assure correct alignment of the upper and lower ball joint when checking for bent spindles.
• Insert slugs into spindle and guide rod will fit through slugs if spindle isn't bent.
• Kits fit most aftermarket race and GM stock metric spindles.

• Allstar Rivet Gun Adapter for Cordless Drill.
• Adapter is for reversible cordless drills.
• Greatly speeds up the installation of "blind" rivets commonly used when building race car bodies. T
• Tool is a real hand and time saver compared to hand operated rivet guns.
• Designed for use with all rivets up to 3/16" including 3/16" aluminum mandrel rivets (not recommended for 3/16" steel mandrels).
•Adapter includes nosepieces for installing 3/32", 1/8", 5/32" and 3/16" rivets.

• Driveshaft Loop 180 Degree 1" x .083" Round Tubing
• Pre-bent 1" diameter x .083" wall mild steel tubing is designed for chassis style cars to help retain the driveshaft in the event of a u-joint failure.
• Loop is 10" tall overall and has a 5" I.D.

• High temperature silicone heating pads externally preheat oil in wet sump oil pans, dry sump tanks and automatic transmission pans reducing overall warm up time and improving lubrication during initial start up.
• 3" cord, 120-volt operation
• Heating Pad 6" x 12" Velcro, 435W
• These are not thermostatically controlled, units will continue to heat as long as they are plugged in.