Shopping

• Helmet Blower System.
• Remote mount breather system directs filtered, forced air to the driver's helmet for added comfort and safety.
• Motor assembly has a mounting bracket for easy mounting to chassis or seat back.
• 4 ft. helmet hose connects to most helmet fresh air intakes with standard 1-1/4" connector.
• The 9 ft. extension lead can be easily connected to a switched 12-16 volt source.
• This system weighs 2-1/4 lbs, and draws 3.5amps at 13.6 volts, and produces about 90 cfm of air to the driver.
• Provides more than enough air to keep the driver cool and shield clear.

• Nose Wing Wall Mount.
• Brackets attach to the side of trailer wall to hold a spare sprint car front nose wing safely in place.
• Powder coated aluminum brackets feature slotted arms which are fully adjustable to accommodate a variety of nose wing shapes and sizes.
• Sold in pairs with retention straps to keep wing secure.

• Designed specifically for circle track use on internally balanced small block Chevys
• Aluminum crank hub is significantly lighter than harmonic balancers
• Dramatically reduces rotating weight for quicker acceleration off the turn
• Hub has 4-3/8" diameter and timing marks at 0° and from 30-42°
• Features (3) 3/8"-16 accessory threads
• Weighs just one pound

• Titanium Top Wing Height Adjust Pin Kit
• Kit includes (2) 1/4" x 1" pins with locking clips
• For adjusting top wing tree height

• 3/16" Flip-Over Clip With 6" Lanyard
• 3/16" flip-over clip commonly used with hood pins
• Has an added 6" lanyard which fastens to body panel for easy installation and prevention of lost clips
• Sold each

• Plastic Storage Case 15 Compartments
• Helps organize many items around the shop, trailer or home such as electrical connectors, quick turn fasteners, tire groover and siper blades, small screws, fasteners and many more items
• Curved bottom compartments create a smooth scoop making it easy to remove the smallest of items
• Molded-in dividers prevent items from slipping under dividers and accidentally mixing product

• GM Metric Rear Lower Trailing Arm
• New, stamped steel, C-channel arms are strong and sturdy.
• Improve handling of the rear suspension on 1978-88 GM metric chassis by replacing twisted or worn out rear control arms.
• Sold each.

• Plastic exhaust block off plate set
• 1/4" 1-piece design seal Spread Port/Dart Excluding 23° SB Chevy exhaust ports
• Work great during engine storage or repairs
• Plates protect against moisture, dust and dirt
• Sold in Pairs

• Set-up plates are used for squaring and stringing chassis to ensure accurate chassis set-up by eliminating wheel and tire differences.
• Plates are 1/2" thick and can also be used when setting bump steer or checking axle tubes for straightness.
• Sold each.
• Set Up Plate 5x5, 7" x 28"