Shopping

• 9'' long
• 1"-8 coarse thread screw jack with slic pin tip

• 12'' long
• 1"-8 coarse thread screw jack with slic pin tip

• 2-1/2'' tall cups & 6'' hollow screw jacks for a lightweight combo.
• Will keep your springs happy during travel by allowing rotation and angular alignment.
• Works with our hollow screw jacks or you can run them on a stud on the rearend.
• Cup comes off by simply pushing the SLIC pin. This Patented SLIC Pin technology makes spring changes a breeze.

• 4'' tall cups & 6'' long 1'' hollow screw jacks for a lightweight combo.
• Swivel cups will keep your springs happy during travel by allowing rotation and angular alignment.
• Works with Wehr's hollow screw jacks or you can run them on a stud on the rearend.
• Instead of a bolted together combo, cup comes off by simply pushing the SLIC pin.
• This Patented SLIC Pin technology makes spring changes a breeze.

• 5-1/2'' Swivel spring cup
• 4'' tall 6'' long 1'' screw jack

• 10'' long
• 1"-8 coarse thread screw jack with slic pin tip

• The inner tie rod studs have 5/8" right hand threads that measure 3-1/2" long and 7" from the joint centerline to the end of the thread
• Goes into the stock center link or any center link that uses the stock 7 degree taper
• NOT IMCA LEGAL

• Wehrs firewall flange bearings feature a lightweight aluminum housing with the same bearing as Wehrs steering column mount.
• The lightweight aluminum housing will not melt due to engine heat.
• Support your steering shaft without a lot of welding and/or fabricating.
• .757ID COM bearing

• Thermostat riser with the -16 AN bung welded to it for a clean one-piece option when running a AN upper radiator hose and the remote lines to the rear of the intake to prevent vapor pockets.
• The riser is made from 1'' aluminum and has 2 ports taped with 1/4'' NPT thread.
• Bottom is flat and will use stand gaskets.
• Will fit any small block Chevy.
• Does not come with hardware, gaskets, fittings or plugs.