Product Search

• GM Throttle and Cruise Control Stud Kit
• For Holley performance carburetors that will be used on GM applications
• Steel with Zinc finish
• Includes nut

• Lock Washer
• Tab
• Steel
• Rear
• 2-1/2 in Grand National Spindle Nut
• Sold Individually

Aeromotive recommends annual inspection and service of filter elements. This includes replacing 10-micron fabric elements and cleaning or replacing 100-micron stainless steel elements. Severe duty applications or newly installed systems may require more frequent maintenance.

For Filter P/N’s: 12301, 12306, 12351, 12321

Wilwood’s Adjustable Forward Mount Pedal Assembly combines the brake and clutch pedals together in one unit and positions the master cylinders outside the firewall. It features all aluminum frame and forged aluminum pedal arms with ladder style construction. Pedal pads are of special adjustable design that allows fine-tuning of the pedal location and clearance. Also included with the assembly: mounting studs, hardware, new clevis and pivot pin balance bar assembly to provide smooth and accurate settings of the brake pedal bias. The balance bar can be set and locked down with the jam nut, or attached to a remote cable for quick on-track adjustments. With a 6.25 to 1 pedal ratio on both clutch and brake pedals.

• Aluminum forward swing amount pedal assembly
• Adjustable triple master cylinder
• Includes adjustable brake balance bar
• Fully adjustable aluminum pedal pads with waffle style non-slip surface
• High strength forged aluminum ladder style pedal arms
• Brake and clutch pedal have 6.25:1 ratio
• Both pedal lengths are 12.05"
• Easy mounting location with full interchangeability with Wilwood pedals of the same type and style
• Includes mounting studs, hardware, new clevis and pivot pin balance bar assembly

• Master disconnect switch
• Most sanctioning bodies require these for emergency cutoff switch
• Red epoxy-coated handle & mounting plate
• Panel 2-1/2"W x 2-1/2"H

At DaVinci Performance Carburetor ... We Make Horsepower! Our engineers aim to lead the industry in the research and development of fuel induction systems for products that exhibit maximum horsepower, engine efficiency, and environmental viability. You will find the very best workmanship in our custom carburetor modifications. Our promise to you is an out-of-the-box carburetor that will need minimal tuning.

• DaVinci Racing New Modified Holley® 4412 Carburetor
• Custom designed and modified for Circle Track Racing
• Aluminum with polished finish for great look
• Accelerator system modified to provide sharp dependable throttle response and prevent overfueling at higher RPM
• Includes Gaskets
• Fuel Type: Gasoline
• CFM: 350 CFM
• Choke Type: Manual
• Flange Type: 2-Barrel 4-Bolt
• Ready to run out of the box
#NOTE: Due to the California Air Resources Board (CARB) restrictions, we no longer ship carburetors to the state of California.

• Sprint Car Header
• Welded to clear 4 inches from head to inside of header
• Forward Design for additional muffler clearance
• 32" primary, 18 gauge tubing, long collector
• Forward Design for additional muffler clearance
• Bolts & gaskets included

• Right side kick panel
• 2-Piece design
• Aluminum construction
• Pre-fit for nerf bars, long radius rod mounts, standard radius rods, & jacobs ladder
• Dzus holes not drilled