Product Search

• Small Block Chevy Spiral Core Sleeved Wire Sets
• 8 mm 800 ohm Spiral Core Wire pre-terminated at both ends
• Complete, pre-assembled ready to install sets with 36" coil wire
• Each wire is tested for continuity and resistance after termination to ensure race-ready performance
• High-temp silicone 90° Black spark plug boots provide maximum heat protection
• Shrink tubing at each ends completes the wire-to-boot sealing
• Numbered ID tags simplify installation
• Application Options: Over Valve Cover or Under Header
• Distributor Cap Style: HEI or Non-HEI
• Insulating sleeve runs the entire wire length, adding 8,000 volts of additional insulation
• Available in Black, Red or Blue with Smiley's logo on connector

• Aircraft safety flip-up switch cover only

• Ignition switch with flip-up aircraft safety cover
• 2 terminals
• Heavy duty 40 amp switches
• Silver plated contacts
• Solid brass mechanisms
• Tough phenolic bodies

Shock components take a beating. Outerwears Shockwears® are designed to reduce the wear and tear on parts such as the shafts and seals. Sand and dirt act as sandpaper against the seals and the shock shaft. By reducing the amount of dirt and debris that wears down the shafts and seals, you will prolong the life of the shock and maintain peak performance.

• Material: Denier
• Shock Circumference: 11"
• Shock Length: 14"
• Sold in Pairs

• Racing ICP05 panel includes ignition switch, starter button & pilot light
• Ignition flip switch cover
• Panel 3-3/8"W x 4-1/4"H, pre-wired
• Bridged double-pole switches, waterproof boots & large gauge copper wires with heavy-duty .040 thick connectors
• High temp 105°C insulation impervious to acids, oils & fuel
• Crimped & soldered connectors for tensile strength 15,000 psi

• Racing ICP10 panel includes ignition switch & starter button
• Ignition switch flip cover
• Panel 4-5/8"W x 4-3/8"H, pre-wired
• Bridged double-pole switches, waterproof boots & large gauge copper wires with heavy-duty .040 thick connectors
• High temp 105°C insulation impervious to acids, oils & fuel
• Crimped & soldered connectors for tensile strength 15,000 psi

• Stainless steel rear bumper with basket
• CNC bent & jig built for quality & exact fit
• Fits most chassis (PMP)
• Top Width: 23" (Center to Center)
• Bottom Width: 22" (Center to Center)
• Tube Diameter: 3/4"
• Wall Thickness: .065"
• Finish: Polished
• Total Weight: 8.25 lbs

• 4130 Chromoly, plated rear bumper
• With post (but no basket)
• Post helps avoid push truck (and other cars) from jumping the bumper, and getting into the tank
• CNC bent and jig built for quality and exact fit
• Fits most chassis

• Premium quality timing cover bolt kit
• Black oxide finish 8740 chrome
• Washers included
• 12-Point head style
• Application: All Chevy V8