Item # MPI-A-CP-F• MPI Polyurethane Center Pad For All F Models
• Perfect for Off Road Racing
• Dirt Friendly / washable
• Weight: 0.26 lbs – 120 g
• Fits only: F-13, F-14
Item # MPI-GT-11• Aluminum Frame
• Highest quality suede
• Oval/extreme ergonomic grip
• Flat bottom to facilitates entering and exiting the car
• Hole pattern: European 3 hole
• Diameter – 11.25 inches // 285mm
• Weight – 1.25 lbs
• Dish Depth – None
Item # MPI-GT-11-CUT• Aluminum Frame
• Bright orange stripes embedded on grip
• Highest quality suede
• Oval ergonomic grip
• Open upper part facilitates inserting and improve vision on dashboard
• Flat bottom to facilitates entering and exiting the car
• Spoke: 3 solid spokes
• Diameter – 10.75 inches // 270mm
• Weight – 0.87 lbs // 395g
• Dish depth – None
• Grip section – 1.33 inches x 0.94 inches // 34mm x 24mm
Item # QCC0232K• PEM Quick Change Bolt-On Upper GM Metric Mount Kit for Housing
• Fits Quick Change Rear Ends, PEM, Winters, DMI, Tiger and Frankland Rears.
• 4 degrees down pinion angle built in with stock length radius rods
• Poly top bushings for stock style General Motors radius rods
• Raw Mild Steel, Not painted
Item # REM-PLMETRIC• PEM GM Metric Bearing and Race Kit with Seal for One Wheel
• REM Finished
• Polished bearings and races for GM Metric front hub (LM12649, LM12610, LM67048, LM67010)
• Two bearings and two races for one wheel - micro polished
• With standard hub seal
• Used in IMCA/USRA stock car classes and many other stock car racing series
• Common bearings for GM metric mid size cars 1978-1988
Item # REM-ZGNBRKIT• PEM Grand National Bearing and Race Kit for One Wheel
• REM Finished ISF ® Micro Polished GN 2.5" ID hub bearing and Race set
• Polished bearings and races for GN hub with 2.5" ID bearing (BL610549)
• Two bearings and two races for one wheel
• Micro polished for less drag and friction
• Common bearings for IMCA type modifieds and asphalt late models
Item # HB2025• Hose bender works great with Smiley's Racing race jugs
• So simple to use, just snaps on your filler hose
• Bends the hose to a 45 degree angle
• Gives you an extra hand in refilling
• Helps reduce liquid refill spillage
• Sold as 2/pack
Item # WM311ST• Replacement tube ONLY for RF tie rod with a LH stock inner
• Tube is made like our 5/8" suspension tubes with 13/16" hex on each end
• Approximately 15" long and is lasered with thread direction (15" tube only)
Item # P208Z• Z Optics Sealed Tear Off - 12-1/8" P208Z
• Includes 3 sets of 8 stacks
• Visual Light Transmission = 90% compared to competitors at 83.7%
• Optical Haze = .73% compared to competitors at 2.67%
• Helmet Fitment: Bell (BR.8, Dominator.2, GTX.2, GP.2, M.8, 287 Shield, Star), Zamp (FS-2, Z-15 or Z-20 Shields, Z-70), G-Force (Revo, Rift, Rookie) and RJS
• Note: Use Front/Back stickers to carefully remove Blue (Front) and Green (Back) protective films