Product Search

• Racing ICP05 panel includes ignition switch, starter button & pilot light
• Ignition flip switch cover
• Panel 3-3/8"W x 4-1/4"H, pre-wired
• Bridged double-pole switches, waterproof boots & large gauge copper wires with heavy-duty .040 thick connectors
• High temp 105°C insulation impervious to acids, oils & fuel
• Crimped & soldered connectors for tensile strength 15,000 psi

• Racing ICP05 panel includes ignition switch, starter button & pilot light
• Panel 3-3/8"W x 4-1/4"H, pre-wired
• Bridged double-pole switches, waterproof boots & large gauge copper wires with heavy-duty .040 thick connectors
• High temp 105°C insulation impervious to acids, oils & fuel
• Crimped & soldered connectors for tensile strength 15,000 psi

• Green pilot light replacement
• For QuickCar ignition switch panels

• Includes holder for lightweight 9V battery
• Low oil pressure switch, 20 psi
• Warning light
• Heavy duty mag kill switch
• Weatherproof switch cover
• Wire & terminals
• For low oil pressure warning light

• Ignition/start switch combination
• DOWN is off
• MIDDLE is Ignition On
• UP is momentary start
• Comes pre-wired with color coded harness & flip-up switch cover
• Heavy duty 40 amp switches
• Silver plated contacts
• Solid brass mechanisms
• Tough phenolic bodies.

• Retard Module Selectors allow you to select between 12 retard amounts with the turn of a dial
• Selectors plug into the retard module receptacle of any MSD Timing Control
• 0-11° retard range, in increments of 1°

• On/Off double pole with bridges connecting the (2) top poles together and (2) bottom poles together
• Works well for 12 volt electrical systems
• Designed to Fit 1/2" I.D
• Mounting Hole
• Sold each

• RPM-Activated Switch performs variety of functions from turning on bulb or solenoid to activating Timing Control at a desired rpm
• 2 activation wires - 1 to ground a circuit & the other to open a circuit
• Plug in an rpm module & wire Switch to the circuit you want to activate
• Activates circuit when rpm reaches set amount & remains on until rpm falls below set amount
• Can be used with stock inductive ignitions or an MSD Ignition
• Can handle up to 1.5 amps
• No rpm modules are supplied

• Designed for #6 ring terminals
• Fits in 1/2" I.D
• Mounting hole
• Rated for 25 amps at 12V