• Set 3 RPM limits - Burnout rev limiter, Launch rev limiter & Top End rev Limiter • Different rpm limits can be activated at different times • Module Selectors can be used with MSD Timing Control • By plugging Selector into a retard module socket, you can activate different retard amounts at select times • Module Selectors must be used with an MSD Soft Touch Rev Control or a Timing Controller with a high-speed retard module • No rpm or retard modules are supplied
• RPM Module Selector plugs directly into rpm module socket on all MSD Soft Touch Rev Controls & accessories that use plug-in modules • User selects between 12 rpm limits by turning knob • Range of 3,000 to 5,200 rpm in 200 rpm increments
• RPM Module Selector plugs directly into rpm module socket on all MSD Soft Touch Rev Controls & accessories that use plug-in modules • User selects between 12 rpm limits by turning knob • Range of 4,600 to 6,800 rpm in 200 rpm increments
• RPM Module Selector plugs directly into rpm module socket on all MSD Soft Touch Rev Controls & accessories that use plug-in modules • User selects between 12 rpm limits by turning knob • Range of 6,000 to 8,200 rpm in 200 rpm increments
• Retard Module Selectors allow you to select between 12 retard amounts with the turn of a dial • Selectors plug into the retard module receptacle of any MSD Timing Control • 0-11° retard range, in increments of 1°
• Allows a launch rev limiter & a high speed rev limiter • Different rpm limits can be activated at different times • Module Selectors can be used with MSD Timing Control • By plugging Selector into a retard module socket, you can activate different retard amounts at select times • Module Selectors must be used with an MSD Soft Touch Rev Control or a Timing Controller with a high-speed retard module • No rpm or retard modules are supplied
• RPM Module Kits include five modules in 200 rpm increments • Each kit is within a 1,000 rpm range • 5,000 Range Kit comes with: 5,000, 5,200, 5,400, 5,600, 5,800 modules
• Master disconnect switch with alternator posts • Most sanctioning bodies require these for emergency cutoff switch • Red epoxy-coated handle & mounting plate • Panel 2-1/2"W x 2-1/2"H
Super Duty switch with rating of 2,000 amps intermittent and 300 amps continuous is perfect for engines with large starter draw, RVs, Drag Cars with alternators, and other applications. • Two pairs of copper studs (1/2"-20 & 10-32) make it ideal for disconnecting alternator (or other electrical device) in addition to the battery • Sealed shaft keeps out moisture and debris • Indexing pin aligns switch with mounting panel and prevents rotation; fits mounting panels up to 1/4" thick • Includes switch position face plate; also includes decal to indicate switch location during emergencies
• Battery Disconnect Switch, Limited-Service, i.e. Drag Race applications without Alternators • Rating: 20 amps @ 6-36 volts DC • Easy to install • Required by many sanctioning bodies • A quick twist of the non-slip handle shuts off all electrical current to the electric fuel pump, electric water pump, ignition, instruments, etc. • For drag racing vehicles, the switch should be mounted on the vehicle's rear panel for easy accessibility • For oval track and road racing applications, the switch should be mounted so that it can easily be reached by the driver or service personnel from outside the vehicle • In street applications, the switch can be hidden to thwart car thieves • Use Push/Pull Switch Kit No. 74105 for remote installation for Nos. 74100 & 74101