Suspension Accessories

• Black anodized
• Billet aluminum grand national hub socket with 1/2" drive.
• 1/2" deep pocket and four tabs to lock onto the axle nut.

• Suspension Limiter Chain Mount
• 1-1/4'' tube
• Quick Adjust
• Bolt-In
• Bellville Spring
• Black Oxide Steel
• IMCA Legal

• Suspension Limiter Chain Mount
• 1-1/2'' tube
• Quick Adjust
• Bolt-In
• Bellville Spring
• Black Oxide Steel
• IMCA Legal

• Suspension Limiter Chain Mount
• 1-3/4'' tube
• Quick Adjust
• Bolt-In
• Bellville Spring
• Black Oxide Steel
• IMCA Legal

• Magnetize to the inside of your brake rotor, so you can always guarantee that you are measuring from a true point unlike others requiring you to measure from a bent wheel.
• Swiveling tape measures on the left side toe plate will span to the right side plate and attach to the magnets to hold your tape measure. Once the tape measures have been connected, just level your plates and make your adjustments.
• You will watch your adjustments be made in real time with no guess work!
• These work with 1"-4" Backspacing

• Magnetize to the inside of your brake rotor, so you can always guarantee that you are measuring from a true point unlike others requiring you to measure from a bent wheel.
• Swiveling tape measures on the left side toe plate will span to the right side plate and attach to the magnets to hold your tape measure. Once the tape measures have been connected, just level your plates and make your adjustments.
• You will watch your adjustments be made in real time with no guess work!
• These work with 1"-4" Backspacing

• These short chassis (axle) set-up blocks are adjustable from 1.75" to 4" in 1/8" increments.
• Mostly used to set ride height of the front end (for the front axle).
• A quick release pin holds block at desired height. Bottom surfaces of blocks are contoured to ?t steel tubing or any ?at surface and have magnets for holding block to chassis when in use.
• Sold as pair.
• Each block contains two internal slide brackets (with poly top) to reach the desired heights.
• Finish: Black Anodize
• Use PA-5502 for the rear of the car.

• These tall chassis (axle) set-up blocks are adjustable from 3" to 6" in 1/8" increments.
• Mostly used to set ride height of the rear end (for the rear axle).
• Sold as pair.
• A quick release pin holds block at desired height. Bottom surfaces of blocks are contoured to ?t steel tubing or any ?at surface and have magnets for holding block to chassis when in use.
• Finish: Black Anodize
• Use PA-5501 for the front of the car.

• Bump Stop
• Weather resistant and easily adjustable by adding packers to the inner ring
• 3" Tall
• 1-5/8 in OD
• Five 1/16" thick packer shims included in kit
• Polyurethane
• Black