Item # RT-66• RT-66 Pneumatic Rivet Tool - Big Power in a little package
• Included with Tool: 3/32", 1/8", 5/32" and 3/16" nose pieces, nose piece wrench and plastic mandrel catch can
• Rivet Setting Capacity: Steel - 3/32", 1/8", 5/32", 3/16", Aluminum - 3/32", 1/8", 5/32" & 3/16", Stainless Steel - 3/32", 1/8", 5/32"
• Traction Power: 1300 lbs
• Air Inlet: 1/4"
• Length: 7.7"
• Weight: 2.8 lbs
Item # 1775Timing or leveling your Birdcages is one of the most important parts of any chassis set-up. This new tool will make doing the job a snap! It’s CNC machined from ABS plastic and neatly snaps around your upper rear radius rod bolt sleeve and slips down around the rear axle O.D., then just center the bubble in the level and you’re done. Fits Maxim, Eagle, and any other style where the bolt runs parallel to the Axle. This is a great tool and will eliminate any guess work.
Item # WM265• Black anodized
• Billet aluminum grand national hub socket with 1/2" drive.
• 1/2" deep pocket and four tabs to lock onto the axle nut.
Item # WM28500• 1/2'' set
• Unique heim center finders are designed to allow the racer to set up spare arms once the car is set up
• This is done simply by removing the arm, bolting the tape measure center finder into one end and placing the center pointer on the other and measuring.
• When you establish a measurement place the finder set into the spare and adjust to match the length of the heim.
• When the tape end is bolted in, snug it, hook it, and pull it to let the finder square itself. then just tighten, and you are ready to go.
• Product is designed to take the work out of eyeing up bolts in a critical situation when an identical spare is crucial.
• Finder sets are available for 1/2'', 5/8'', and 3/4''. 1/2'' set.
Item # PA-5501• These short chassis (axle) set-up blocks are adjustable from 1.75" to 4" in 1/8" increments.
• Mostly used to set ride height of the front end (for the front axle).
• A quick release pin holds block at desired height. Bottom surfaces of blocks are contoured to ?t steel tubing or any ?at surface and have magnets for holding block to chassis when in use.
• Sold as pair.
• Each block contains two internal slide brackets (with poly top) to reach the desired heights.
• Finish: Black Anodize
• Use PA-5502 for the rear of the car.
Item # PA-5502• These tall chassis (axle) set-up blocks are adjustable from 3" to 6" in 1/8" increments.
• Mostly used to set ride height of the rear end (for the rear axle).
• Sold as pair.
• A quick release pin holds block at desired height. Bottom surfaces of blocks are contoured to ?t steel tubing or any ?at surface and have magnets for holding block to chassis when in use.
• Finish: Black Anodize
• Use PA-5501 for the front of the car.