Item # 20-36• GM Throttle and Cruise Control Stud Kit
• For Holley performance carburetors that will be used on GM applications
• Steel with Zinc finish
• Includes nut
Item # 20-37• Holley throttle stud kit
• Throttle Stud is 7/32" diameter
• Thread size is 1/4"-18 UNF
• Steel with Zinc finish
• Includes nut
Item # 26041• Dominator style carb hat
• Plastic carb hat is 2-3/8" Tall
• Fits over the 7-1/4" air cleaner opening of Holley Dominator 4500
carburetors
• Prevents water or debris from entering the engine
• Solid cover may be drilled when an air cleaner stud is used
Item # 26200• Carburetor Rebuild Stand
• Aluminum stand simplifies carburetor maintenance
• Will hold carburetor off of work bench surface
• Works with Edelbrock, Quadrajet, and Holley 2- and 4-barrel carbs (except 4500 series)
Item # 37960• Carburetor Stud Kit fits carbs with 1/2" thick flange base with a 1" spacer or with one or two 1/2" spacers
• 5/16" -18 and 24 x 2-1/2" long
• "Bullet Nose" studs allow for easy start when installing jam nuts
• Kits include 4 studs, hardened flat washers and jam nuts
Item # 37961• 3-1/2" Carburetor Stud Kit fits carbs. with 1/2" thick flange base with a 2" spacer or with three or four 1/2" thick spacers
• 5/16" -18 and 24 x 3-1/2" long
• "Bullet Nose" studs allows for easy start when installng jam nuts
• Kits include 4 studs, hardened flat washers and jam nuts
Item # 62293• Carburetor Jet Tool
• Designed with a stronger, fully machined tip that slides over jet, holding it firmly in place
• Short design, sure-grip handle simplifies jet removal and installation in crowded engine compartments
• Fits all Holley® round-head type carb jets
Item # 64920• Carburetor Linkage Bushing Kit
• Steel linkage bushing set allows the fitting of a 1/4" fastener to the 1/2" diameter hole found in the throttle linkage plate of Holley® 4 barrel carbs
• Split bushing design permits simple installation and eliminates the sloppiness present when rubber bushings are used
• Clear zinc finish
Item # 64940• 1" 4150/4160 Carburetor Spacer
• Open Plenum Design with 3.62" ID Square
• Advanced plastic compound, specially formulated to reduce heat conductivity 10 times greater than aluminum
• Reducing fuel temperature inside the carburetor results in a denser, more powerful fuel charge to the manifold
• Includes all mounting hardware
• Gaskets not included
Item # 65015• 4150/4160 Carburetor 1/2" Thick Wood Spacer
• Open Plenum Design
• Unique 1/2" spacers are precision machined on state-of-the-art millworking centers, can be used individually or stacked
• Requires the installation of a gasket on either side of the spacer whether the spacer is individual or stacked
• Thin layers of choice laminated hardwood, bonded together with resin, form a natural thermal barrier
• Top-quality hardwood has a sheet of phenolic resin- impregnated paper bonded to both sides
• Can be easily modified to your particular manifold for optimum performance
• Gaskets are not included