Shopping

• Moroso Clevis Ends are designed to help solve all kinds of fastening and suspension problems where rod ends would not be practical
• Allows adjustment both radially & laterally while placing the holding bolt under shear load
• 1 2" -20 thread on shank, 5 16" bolt holes, 1 4" slot
• 4130 chrome moly steel with yellow zinc finish
• Two per package

• Specially designed gaskets are manufactured from 40 durometer rubber, molded over and vulcanized to a rigid steel frame
• Extra-strength design will not leak, blow out or get sucked in like stock or inferior-quality aftermarket gaskets
• Superior quality silicone/steel gaskets outlast cork and rubber composite designs to provide years of dependable service, especially when constantly removing and reinstalling valve covers
• 3/16"-thick
• Two per package

• Specially designed gaskets are manufactured from 40 durometer rubber, molded over and vulcanized to a rigid steel frame
• Extra-strength design will not leak, blow out or get sucked in like stock or inferior-quality aftermarket gaskets
• Superior quality silicone/steel gaskets outlast cork and rubber composite designs to provide years of dependable service, especially when constantly removing and reinstalling valve covers
• 3/16"-thick
• Two per package

• Designed to work with Fabricated Sheet Metal and Cast Aluminum Valve Covers, without logo, that have a 1-1/4" diameter hole
• Replacement Valve Cover Grommets for breathers and oil filler caps
• Two per pack

• Designed to be used either by itself or in conjunction with our Upper Coil-Over Shock Mount Kit
• Provides a solid, adjustable mounting point for racing coil-over shocks
• Fits housings with 3" O.D. axle tubes
• Allows 6" of height adjustmnet in 1/2" increments
• 1/4" thick housing brackets, 3/16" thick shock brackets
• Fits most popular coil-over shocks
• Includes Grade 8 hardware and spacers for mounting two shocks
• Welding required

• Replaces weld-in axle brackets found in Nos. C2047 & C2051 Lower Coil-Over Shock Mount Kit
• 1-1/2" radius accepts 3" dia axle tube
• 3/8" shock bracket mounting holes
• Stamped from 1/4" hot rolled steel
• One per package; two brackets required per car

• Replacement bracket, also used in Nos. C2047 & C2051
• Stamped from 3/16" cold rolled steel
• 3/8" bracket mounting holes
• 1/2" shock mounting hole
• One per package; two of each bracket required per car

• Replacement bracket, also used in Nos. C2047 & C2051
• Stamped from 3/16" cold rolled steel
• 3/8" bracket mounting holes
• 1/2" shock mounting hole
• One per package; two of each bracket required per car

• Used to adjust pinion angle or change traction bar angle on leaf spring equipped cars and trucks
• Allows pinion angle change in 2° increments
• Made from 6063-T5 aluminum, they won t crack like cast zinc
• Interlocking ribs allow plates to be stacked without sliding and eliminate unwanted pinion angle change
• Two per package